VMware VCENTER SERVER 4.0 - GETTING STARTED UPDATE 1 Installation Guide download pdf (Page 58)

Installation Guide

58 VMware, Inc.

SERVERROLE:SECONDARY

BACKUPSOURCEPATH:\\<192.168.15.111\nf backup>

BACKUPUSER:Administrator

2 Rename the self-extracting file from <name>.exe to <name>.zip

3 Extract the contents of the self-extracting file into a temporary folder.

4 Navigate to Start > Run and type CMD to open a command window.

5 Navigate to the to the location of the temporary folder.

6Run the command:

start /wait setup –f:<parameter file> -BACKUPPassword:<backup password> -ni

7 Upon completion of the unattended installation, launch the Configure Server wizard to configure the

Secondary server.

8Click the Public tab.

9 In the Public Identity/Mode pane, select Non-Identical.

10 Enter the Name used to connect to vCenter or SQL Server.

11 In the NIC drop-down, select the Principal (Public) NIC.

12 In the Public IP drop-down, select the Principal (Public) IP address assigned to the Principal (Public) NIC.

13 In the first Mask field, enter the Subnet Mask of the Principal (Public) IP address.

OTE The parameters enclosed in <> can be enclosed in double quotes (") and should be if they

contain spaces, dashes or other potentially confusing characters.

NOTE If installing into an environment that uses Windows Server 2008 R2 for DNS, you must configure

a security level on the DNS server that permits changes to DNS.

OTE The Name used to connect to vCenter or SQL Server is the DNS name by which application clients

connect to the application. Normally this is the original name of the vCenter Server or SQL Server. There

is only one Name used to connect to vCenter or SQL Server and it is the same on all servers in the cluster.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 71 72

No comments

VMware VCENTER SERVER 4.0 - GETTING STARTED UPDATE 1 Installation Guide Page 58