VMware VCENTER SERVER 4.0 - GETTING STARTED UPDATE 1 Installation Guide Page 39

  • Download
  • Add to my manuals
  • Print
  • Page
    / 72
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 38
VMware, Inc. 39
Chapter 3 Installing vCenter Server Heartbeat
7 The pre-install checks run. Click Next.
If any of the pre-install checks are unsuccessful, go back through the wizard, make the necessary changes,
and run the pre-install checks again.
You have the following options:
If installing on Windows Server 2003, continue with Step 8.
If installing on Windows Server 2008, go to Step 29.
8 The next page displays the progress of the installation. During this process, Setup installs the necessary
files and folders onto your system and applies the configuration you specified. Setup also installs
Heartbeat Diagnostics and configures it with the default settings.
9 The Report pane displays the results of the installation. Click Next.
10 The progress of the VMware vCenter Server Heartbeat Packet Filter installation is displayed. Click Next.
You have the following options:
If the Secondary server is physical, go to Step 11.
If the Secondary server is virtual, continue with Step a.
a The Packet Filter is installed on the Principal (Public) NIC and the Principal (Public) network adapter
can be reconnected. Right-click the Secondary server image name and select Edit Settings.
b Select the Principal (Public) virtual network adapter, select the Connected and Connect at power on
check boxes, and click OK.
11 In the Channel Adapter Identification page, select the appropriate adapter and review the IP address
configuration in the lower pane. Click Next.
You have the following options:
If the Secondary server is physical, continue to Step 12.
If the Secondary server is virtual, go to Step 15.
12 Configure the Principal (Public) adapter on the Secondary server through the Public Adapter
Identification page. When you select the Principal (Public) adapter, a caution message notifies you that
the IP address on the Principal (Public) adapter does not match the IP address on the Primary server (LAN
configuration only). Click OK.
N
OTE If the Secondary server is virtual, the pre-install checks will return the message that the Primary
and Secondary servers names match. This is expected and installation will be allowed to continue.
Page view 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 71 72

Comments to this Manuals

No comments