VMware VCENTER SERVER 4.0 - GETTING STARTED UPDATE 1 Installation Guide Page 32
- Page / 72
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Installation Guide
32 VMware, Inc.
21 The VMware Channel IP Configuration page prompts you to configure the VMware Channel(s) IP
network addresses. Click Add for each available channel connection. For the Primary server, select from
a drop-down menu that lists all local IP addresses. Type the reciprocal IP address on the Secondary server
into the IP Address On Secondary text box. You must specify all VMware Channel IP addresses in
subnets outside of the normal Principal (Public) IP addressing schema so that VMware Channel traffic
routing uses the VMware Channel network card rather than the Principal (Public) network card. Click
OK. Repeat this step for additional NICs.
22 Review and adjust, if necessary, the default channel port. Click Next.
23 Select the Principal (Public) NIC(s). The IP address information is displayed for each NIC. Click Next.
vCenter Server Heartbeat software can be deployed in a configuration where both servers use the same
Principal (Public) IP address, for instance in a standard Local Area Network (LAN) deployment where
both machines are in the same subnet.
Alternatively, vCenter Server Heartbeat can be deployed where the Principal (Public) IP addresses differ,
for instance, in a Wide Area Network (WAN) deployment where the Primary and Secondary servers are
located in different sites and subnets where client access is therefore bound by the standard network
routing to allow the correct connectivity to the server according to its locale.
24 Select Use same IP addresses for Secondary (Recommended for HA secondary) or
Use different IP addresses for Secondary (Recommended for DR secondary).
You have the following options:
For LAN installation or same subnet WAN installs, continue with Step 25.
For a WAN installation with different subnets, go to Step 26.
N
OTE If the Secondary server is virtual, you will receive a warning message that the Secondary server
cannot be contacted. Disregard the warning and click No to proceed.
NOTE When the implementation spans multiple sites with firewalls between the servers, configure the
firewalls to allow traffic to pass through the default channel port or the manually configured channel port.
Consult the VMware knowledge base for additional information.
N
OTE Adjacent IP addresses should be reserved and used for the Principal (Public) IP address and the
Management IP addresses for the Primary and Secondary Servers when installing vCenter Server
Heartbeat on servers running Windows 2008.
- Installation Guide 1
- 2 VMware, Inc 2
- Contents 3
- Glossary 67 4
- About This Book 5
- Abbreviations Used in Figures 6
- Getting Started 7
- 8 VMware, Inc 8
- Introduction 9
- Server Protection 10
- Network Protection 11
- Application Protection 11
- Performance Protection 11
- Communications 12
- Managed Switchover 13
- Automatic Switchover 14
- Automatic Failover 14
- Managed Failover 15
- 16 VMware, Inc 16
- Installation 17
- 18 VMware, Inc 18
- Implementation 19
- Common Requirements 20
- Server Architecture Options 21
- Cloning Technology Options 22
- Application Component Options 22
- VMware, Inc. 23 23
- Network Options 24
- Primary Server 25
- Secondary Server 25
- WAN Requirements 25
- Antivirus Recommendations 26
- Deployment Options Summary 27
- 28 VMware, Inc 28
- Overview 29
- Installation Process 29
- VMware VirtualCenter Server 30
- vCenter Inventory Service 30
- VMware, Inc. 31 31
- 32 VMware, Inc 32
- VMware, Inc. 33 33
- 34 VMware, Inc 34
- VMware, Inc. 35 35
- 36 VMware, Inc 36
- 38 VMware, Inc 38
- VMware, Inc. 39 39
- 40 VMware, Inc 40
- VMware, Inc. 41 41
- 42 VMware, Inc 42
- VMware, Inc. 43 43
- Renaming the Servers 44
- Resulting IP Configuration 45
- Add a vCenter Server Group 46
- Add a New Connection 46
- VMware, Inc. 47 47
- 48 VMware, Inc 48
- Installation of Client Tools 49
- 50 VMware, Inc 50
- VMware, Inc. 51 51
- 52 VMware, Inc 52
- Server Heartbeat 53
- Parameter File Elements 54
- VMware, Inc. 55 55
- 56 VMware, Inc 56
- VMware, Inc. 57 57
- 58 VMware, Inc 58
- VMware, Inc. 59 59
- VMware, Inc. 61 61
- 62 VMware, Inc 62
- Windows XP 32 bit SP3 63
- Windows XP 64 bit SP2 63
- 64 VMware, Inc 64
- VMware, Inc. 65 65
- 66 VMware, Inc 66
- Glossary 67
- D Data Replication 68
- F Failover 68
- G Graceful (Clean) Shutdown 68
- VMware, Inc. 69 69
- Q Quality of Service (QoS) 70
- S Security Identifier (SID) 70
- VMware, Inc. 71 71
- V VMware Channel 72
Related products and manuals for Servers VMware VCENTER SERVER 4.0 - GETTING STARTED UPDATE 1
Servers VMware ACE EN-000042-00 User Manual
(423 pages)
(423 pages)
Servers VMware ACE Specifications
(14 pages)
(14 pages)
Servers VMware ACE EN-000042-00 User Manual
(24 pages)
(24 pages)
© 2020, manymanuals.com. All rights reserved. | 0.515 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals